Victron Energy SKI024080000 Skylla-i 24V 80A (1+1) Battery Charger

Victron Energy Skylla-i 24V 80A (1+1) Battery Charger: The Skylla-i Battery Charger From Victron Energy Have Been Designed to Be a True World-wide Product

A modern and powerful battery charger that withstands the rigors of an adverse environment: heat, humidity and salt air.

Skylla-i (1+1): two outputs to charge 2 battery banks
The Skylla-i (1+1) features 2 isolated outputs. The second output, limited to approximately 4 A and with a slightly lower output voltage, is intended to top up a starter battery.

Skylla-i (3): three full current outputs to charge 3 battery banks
The Skylla-i (3) features 3 isolated outputs. All outputs can supply the full rated output current.

Rugged
Aluminium epoxy powder coated cases with drip shield and stainless steel fixings withstand the rigors of an adverse environment: heat, humidity and salt air.
Circuit boards are protected with an acrylic coating for maximum corrosion resistance.
Temperature sensors ensure that power components will always operate within specified limits, if needed by automatic reduction of output current under extreme environmental conditions.

Flexible
Next to a CAN bus (NMEA2000) interface, a rotary switch, DIP switches and potentiometers are available to adapt the charge algorithm to a particular battery and its conditions of use.

Victron Energy SKI024080000 Specifications:

Skylla-i

• Input voltage (VAC): 230 V
• Input voltage range (VAC): 185-265 V
• Input voltage range (VDC): 180-350 V
• Maximum AC input current @ 180 VAC: 16 A
• Frequency (Hz): 45-65 Hz
• Power factor: 0,98
• Charge voltage 'absorption' (VDC): 28,8 V
• Charge voltage 'float' (VDC): 27,6 V
• Charge voltage ‘storage’ (VDC): 26,4 V
• Charge current (A): 80 A
• Charge current starter batt. (A): 4 A
• Charge algorithm: 7 stage adaptive
• Battery capacity (Ah): 400-800 Ah
• Charge algorithm, Li-Ion: 3 stage, with on-off control or CAN bus control
• Temperature sensor: Yes
• Can be used as power supply: Yes
• Remote on-off port: Yes (can be connected to a Li-Ion BMS)
• CAN bus communication port (VE.Can): Two RJ45 connectors, NMEA2000 protocol, galvanically isolated
• Synchronised parallel operation: Yes, with VE.Can
• Alarm relay: DPST, AC rating: 240VAC/4A, DC rating: 4A up to 35VDC, 1A up to 60VDC
• Forced cooling: Yes
• Protection Battery: reverse polarity (fuse), Output short circuit, Over temperature
• Operating temp. range -20 to 60°C (Full output current up to 40°C)
• Humidity (non-condensing) max 95%

Enclosure:

• Material & Colour: aluminium (blue RAL 5012)
• Battery-connection: M8 bolts
• 230 VAC-connection: screw-clamp 10mm² (AWG 7)
• Protection category: IP 21
• Weight kg (lbs): 7 kg (16 lbs)