Victron Energy SCC040030050 BlueSolar PWM-LCD&USB 48V-30A

Victron Energy BlueSolar PWM-LCD&USB 48V-30A: A Solar Charger Gathers Energy From Your Solar Panels, And Stores It In Your Batteries

The PWM controller is a switch that connects a solar array to the battery. The result is that the array's voltage will be pulled down to near that of the battery.

A PWM controller is not a DC-DC transformer. The PWM controller is a switch that connects the solar panel to the battery. When the switch is closed, the panel and the battery will be at nearly the same voltage. Assuming a discharged battery the initial charge voltage will be around 13V, and assuming a voltage loss of 0.5 V over the cabling plus controller, the panel will be at V PWM = 13.5V.

The voltage will slowly increase with increasing state of charge of the battery. When the absorption voltage is reached the PWM controller will start to disconnect and reconnect the panel to prevent overcharge (hence the name: Pulse Width Modulated Controller).

The voltage will slowly increase with increasing state of charge of the battery. When the absorption voltage is reached, the PWM controller will start to disconnect and reconnect the panel to prevent overcharge (hence the name: Pulse Width Modulated Controller).

Liquid Crystal Display

For status monitoring and set-up

Load Output

Over-discharge of the battery can be prevented by connecting all loads to the load output. The load output will disconnect the load when the battery has been discharged to a pre-set voltage. Some loads (especially inverters) can best be connected directly to the battery, and the inverter remote control is connected to the load output. A special interface cable may be needed, please see the manual. The connect and disconnect voltages are adjustable.

Day/Night Timing of the Load Output

This option allows for a pre-set ON-time after dusk.

Programmable Battery Charge Algorithm

Preprogrammed algorithms for AGM, GEL, Flooded, or LiFePO4 batteries (with internal BMS only)

Two 5 Volt USB Outputs

Maximum current (both outputs combined): 2A

Victron Energy SCC040030050 Features:

• Pulse Width Modulation Technology
• LCD Screen
• 2x 5V USB Outlets
• Three-stage Battery Charging
• Load Output Protected
• 30Amps