Victron Energy ASS070200100 Cable For Smart BMS CL 12-100 To MultiPlus

Victron Energy Cable For Smart BMS CL 12-100 To MultiPlus: This Cable Connects Between A Non-Ve.bus Bms (Smart Bms Cl 12-100 Or Minibms) And A Multiplus (Multiplus, Multiplus Compact Or Multiplus-ii)

The cable will turn the MultiPlus off as soon as the BMS has detected a low voltage, high voltage, or temperature alarm condition in the Victron lithium-iron-phosphate (LiFePO4) Smart Battery bank. Once the alarm condition has been cleared, the BMS will turn the MultiPlus back on. This cable will allow the MultiPlus 500VA – 1600VA, MultiPlus Compact 800VA – 2kVA, and MultiPlus-II models to be used with BMS products that have no VE.Bus interfaces, such as the Smart BMS CL 12-100 and the miniBMS.

These MultiPlus models can be controlled from the Load/Charge Disconnect outputs and Load/Charger outputs respectively. The cable must be wired to the remote on/off connector of the MultiPlus models:

• When used with the MultiPlus 500VA-1200VA models connect the black wire to the ON terminal and the red wire to the (+) terminal.
• When used with the MultiPlus Compact 800VA-2kVA models connect the black wire to the middle terminal and the red wire to the right (IN) terminal.
• When used with the MultiPlus-II models connect the black wire to the lower (-) terminal and the red wire to the upper (+) remote on-off terminal.

Both the Load/Charge Disconnect outputs of Smart BMS CL 12-100 and the Load/Charger outputs of the miniBMS must be in a ‘High’ state for the MultiPlus to operate. After shutdown due to low battery voltage, run the alternator or use a battery charger on the primary side of the BMS to reset the system. The MultiPlus will then switch on and start charging (if connected to an AC power source).