Projecta EVWHT1 Type 1 EV Cable Holster with Cable Hook

Quick answer

The Type 1 holster and cable hook, made to sit next to the charger on the wall.

The Type 1 holster and cable hook, made to sit next to the charger on the wall. A holstered plug stays clean and off the floor. For a Type 2 plug use the EVWHT2.

It is ABS and PC plastic, with the mounting hardware in the pack.

Three phase supply is not available in every home, so confirm what your switchboard has before planning a three phase charger. Check which connector your car uses, Type 1 or Type 2, before ordering; it is usually shown in the owner's manual or on the charge port flap. Inspect plugs and leads before each use and stop using anything with cracked housings or scorched pins. The car's onboard charger sets the maximum AC charge rate, whatever the cable or charger is rated for. Keep connectors capped and off the ground when not in use, so dirt and water stay out of the pins. Coil cables loosely and avoid driving over them; crushed insulation means the cable should be replaced. The full <a href="https://frankiesautoelectrics.com.au/collections/projecta">Projecta range</a> has the matching accessories.

Specifications

• Suits: Type 1 connector
• Includes: cable hook and mounting hardware
• Material: ABS and PC plastic

Warranty

This comes with the manufacturer's warranty through the Australian distributor. See the manufacturer's terms for details, plus our guarantees under the Australian Consumer Law.

FAQ

Will the EVWHT1 fit a Type 1 plug?

Yes, it is made to suit a Type 1 outlet connector.

Where should the EVWHT1 be mounted?

Projecta says it can be mounted next to a charger.

Does the EVWHT1 come with screws?

Yes, mounting hardware and a cable hook are included.