Projecta EVOCT2 Type 2 EV Outlet Cover

Quick answer

The Projecta EVOCT2 is the Type 2 EV Outlet Cover. A moulded cap for Type 2 outlet connectors.

Projecta says it seals to keep dust and water out.

Useful on a portable cable that lives in the boot.

For the inlet side, see the EVICT2.

Any fixed wiring for EV charging must be done by a licensed electrician. Keep connectors capped and off the ground when not in use, so dirt and water stay out of the pins. Inspect plugs and leads before each use and stop using anything with cracked housings or scorched pins. Check which connector your car uses, Type 1 or Type 2, before ordering; it is usually shown in the owner's manual or on the charge port flap. Most newer EVs sold in Australia use Type 2 for AC charging. Coil cables loosely and avoid driving over them; crushed insulation means the cable should be replaced. Charging speed also depends on the battery state of charge and temperature, so expect it to taper near full. See the rest of the <a href="https://frankiesautoelectrics.com.au/collections/projecta">Projecta range</a> for matching parts.

Specifications

• Suits: Type 2 outlet connector
• Purpose: dust and water seal

Warranty

This comes with the manufacturer's warranty through the Australian distributor. See the manufacturer's terms for details, plus our guarantees under the Australian Consumer Law.

FAQ

Does the EVOCT2 suit a Type 2 outlet connector?

It is moulded for Type 2 outlet connectors.

What is the inlet version of the EVOCT2?

The EVICT2 covers a Type 2 inlet; fit both if you want both ends sealed.

What does the EVOCT2 protect against?

Dust and water, per Projecta.