Projecta EVOCT1 Type 1 EV Outlet Cover

Quick answer

The Projecta EVOCT1 is the Type 1 EV Outlet Cover. Moulded to suit Type 1 connectors, the EVOCT1 seals the plug end between charges.

It keeps dust and water off the pins.

Worth having on a cable that is stored in the back of the car or on a garage floor.

The Type 2 version is EVOCT2.

Charging speed also depends on the battery state of charge and temperature, so expect it to taper near full. Most newer EVs sold in Australia use Type 2 for AC charging. Check which connector your car uses, Type 1 or Type 2, before ordering; it is usually shown in the owner's manual or on the charge port flap. The car's onboard charger sets the maximum AC charge rate, whatever the cable or charger is rated for. Inspect plugs and leads before each use and stop using anything with cracked housings or scorched pins. Three phase supply is not available in every home, so confirm what your switchboard has before planning a three phase charger. Related parts are in the <a href="https://frankiesautoelectrics.com.au/collections/projecta">Projecta range</a>.

Specifications

• Suits: Type 1 connector
• Purpose: dust and water seal

Warranty

This comes with the manufacturer's warranty through the Australian distributor. See the manufacturer's terms for details, plus our guarantees under the Australian Consumer Law.

FAQ

Will the EVOCT1 fit a Type 2 plug?

It is moulded for Type 1 connectors. For Type 2 use the EVOCT2.

Why fit a cover to the EVOCT1 plug end?

Projecta says it seals the connector to keep dust and water out.

Is the EVOCT1 sold singly?

It is listed as one cover.