Projecta EVICT2 Type 2 EV Inlet Cover

Quick answer

The Projecta EVICT2 is the Type 2 EV Inlet Cover. A moulded cover that seals a Type 2 inlet connector when it is not in use.

Handy on a car that lives outside or on dirt roads. For outlet connectors, see the EVOCT2.

Projecta says it creates a seal with the connector to keep dust and water out.

Inspect plugs and leads before each use and stop using anything with cracked housings or scorched pins. Most newer EVs sold in Australia use Type 2 for AC charging. Coil cables loosely and avoid driving over them; crushed insulation means the cable should be replaced. Keep connectors capped and off the ground when not in use, so dirt and water stay out of the pins. Any fixed wiring for EV charging must be done by a licensed electrician. Three phase supply is not available in every home, so confirm what your switchboard has before planning a three phase charger. The car's onboard charger sets the maximum AC charge rate, whatever the cable or charger is rated for. The full <a href="https://frankiesautoelectrics.com.au/collections/projecta">Projecta range</a> has the matching accessories.

Specifications

• Suits: Type 2 inlet connector
• Purpose: dust and water seal

Warranty

This comes with the manufacturer's warranty through the Australian distributor. See the manufacturer's terms for details, plus our guarantees under the Australian Consumer Law.

FAQ

Does the EVICT2 fit an inlet or an outlet?

Projecta lists it for Type 2 inlet connectors.

What does the EVICT2 keep out?

It seals the connector against dust and water.

What cover suits a Type 2 outlet?

The EVOCT2.