Projecta EVCBT2T2 7.2kW Type 2 to Type 2 EV Charging Cable

Quick answer

The single phase 7.2kW cable for charging a Type 2 vehicle at a Type 2 station.

The single phase 7.2kW cable for charging a Type 2 vehicle at a Type 2 station. For three phase stations, the 22kW EVCBT2T2-3P is the matching cable.

Projecta lists IP65 when connected, IK10 impact protection on the connectors, and ergonomic grips.

It comes with a hard wearing EVA storage case.

Coil cables loosely and avoid driving over them; crushed insulation means the cable should be replaced. Keep connectors capped and off the ground when not in use, so dirt and water stay out of the pins. Three phase supply is not available in every home, so confirm what your switchboard has before planning a three phase charger. Most newer EVs sold in Australia use Type 2 for AC charging. Any fixed wiring for EV charging must be done by a licensed electrician. Check which connector your car uses, Type 1 or Type 2, before ordering; it is usually shown in the owner's manual or on the charge port flap. The full <a href="https://frankiesautoelectrics.com.au/collections/projecta">Projecta range</a> has the matching accessories.

Specifications

• Rating: 7.2kW
• Connectors: Type 2 to Type 2
• Protection: IP65 connected, IK10
• Storage: EVA case

Warranty

This comes with the manufacturer's warranty through the Australian distributor. See the manufacturer's terms for details, plus our guarantees under the Australian Consumer Law.

FAQ

Should I buy the 7.2kW or 22kW cable?

EVCBT2T2 is 7.2kW; the 22kW EVCBT2T2-3P suits three phase stations. Your car's onboard charger sets the actual rate.

Is the EVCBT2T2 weatherproof?

IP65 when connected, per Projecta.

Which vehicles suit the EVCBT2T2?

Type 2 vehicles at Type 2 stations. For Type 1 use the EVCBT2T1.