Projecta CL30-50 Cable Lug 25 mm² Cable, 10 mm Stud, Pack of 50

Quick answer

The Projecta CL30-50 is the Cable Lug 25 mm² Cable, 10 mm Stud, Pack of 50. 25 mm² cable onto a 10 mm stud: that is the job for the CL30-50, sold as a pack of 50.

Fifty in the pack makes it a workshop quantity for building starter and dual battery leads.

Use a proper hex or indent crimper sized for the cable, then heat shrink the barrel. The barrel bore is 6.8 mm, matched to the cable size.

Tinned copper, a long barrel that takes a double crimp, and a flared entry so strands do not snag.

Strip only enough insulation for the barrel, so no bare copper shows past the joint. Keep lugs in a sealed tub so they stay bright until used. Use red and black heat shrink to mark polarity at each end. Match the lug to both the cable and the stud; a loose fit on either costs voltage. A tug test after crimping tells you straight away if the joint is sound. Wear eye protection around batteries, as the acid and gases are hazardous. Related parts are in the <a href="https://frankiesautoelectrics.com.au/collections/projecta">Projecta range</a>.

Specifications

• Cable: 25 mm², 3 B and S
• Stud hole: 10 mm
• Barrel internal diameter: 6.8 mm
• Pack: pack of 50
• Material: electro tinned copper

Warranty

This comes with the manufacturer's warranty through the Australian distributor. See the manufacturer's terms for details, plus our guarantees under the Australian Consumer Law.

FAQ

Will the CL30-50 go over a 10 mm stud?

It is made for a 10 mm stud.

Can I use the CL30-50 on 25 mm² battery cable?

Projecta lists 25 mm², 3 B and S, with a barrel internal diameter of 6.8 mm.

Is the CL30-50 a workshop pack or a pair?

The name lists 50, sold as a pack of 50.

Do I solder or crimp the CL30-50?

Crimp it with a tool rated for the cable size; the long shank allows a double crimp. Heat shrink over the barrel finishes the job.