Projecta BT820-P10 Positive Saddle With Dual Auxiliary Satin Brass Battery Terminal, Bag of 10

Quick answer

The Projecta BT820-P10 is the Positive Saddle With Dual Auxiliary Satin Brass Battery Terminal, Bag of 10. Buying for the workshop? The BT820-P10 puts 10 positive saddle with dual auxiliary terminals in one bag.

Buying for the workshop? The BT820-P10 puts 10 positive saddle with dual auxiliary terminals in one bag. Finish is satin nickel over polished forged brass, with stainless steel hardware in the pack.

Positive posts are slightly larger than negative posts, so fit this one only to the positive side. Before fitting, clean any corrosion off the post so the terminal seats properly.

Main cable goes under the saddle; the extra outlets take the smaller accessory wires.

Check the terminal again after the first week, as new cable can settle under the clamp. After fitting, a thin smear of terminal grease or spray protector slows corrosion. If the old terminal was badly corroded, cut the cable back to clean copper before fitting the new one. Measure the post and the cable before ordering; a terminal that is too big for the post will never clamp properly. Keep the positive covered so a spanner cannot bridge it to the body. Tighten firmly but do not crush the post; a lead post deforms easily. Related parts are in the <a href="https://frankiesautoelectrics.com.au/collections/projecta">Projecta range</a>.

Specifications

• Post: positive
• Style: saddle with dual auxiliary
• Pack: bag of 10
• Material: satin nickel plated forged brass

Warranty

This comes with the manufacturer's warranty through the Australian distributor. See the manufacturer's terms for details, plus our guarantees under the Australian Consumer Law.

FAQ

How many positive terminals are in a BT820-P10?

All 10 are positive saddle with dual auxiliary terminals, packed in one bag.

Can the positive BT820-P10 go on the other battery post?

No. Positive posts are slightly larger than negative ones, so this positive terminal is sized for the positive post only.

What finish is on the BT820-P10 and what hardware comes with it?

It is forged brass polished and plated in satin nickel, and Projecta supplies stainless steel hardware with it.

My old saddle with dual auxiliary terminal is cracked; can I just swap in the BT820-P10?

Cut the cable back to clean, bright copper if the old end is green or black, then fit the new terminal and tighten it firmly.

Can I overtighten a saddle with dual auxiliary terminal like the BT820-P10?

Tighten until it cannot be twisted on the post by hand. Going further risks damaging the post or the terminal.