Projecta BT811-N10 Negative Saddle Satin Brass Battery Terminal, Bag of 10

Quick answer

The Projecta BT811-N10 is the Negative Saddle Satin Brass Battery Terminal, Bag of 10. Give the post a clean first; a dirty post will undo a good terminal.

Bag of 10 negative saddle terminals, so this one is aimed at workshops restocking the drawer rather than a single car. Give the post a clean first; a dirty post will undo a good terminal.

Main cable range is 50 to 70 mm², 0 to 00 B and S. A saddle clamp grips the stripped cable directly, no lug needed.

Projecta polishes the forged brass then plates it in satin nickel, and supplies stainless steel hardware. Positive posts are slightly larger than negative posts, so fit this one only to the negative side.

Tighten firmly but do not crush the post; a lead post deforms easily. If the old terminal was badly corroded, cut the cable back to clean copper before fitting the new one. Check the terminal again after the first week, as new cable can settle under the clamp. Keep the positive covered so a spanner cannot bridge it to the body. Measure the post and the cable before ordering; a terminal that is too big for the post will never clamp properly. Related parts are in the <a href="https://frankiesautoelectrics.com.au/collections/projecta">Projecta range</a>.

Specifications

• Post: negative
• Style: saddle
• Pack: bag of 10
• Main cable: 50 to 70 mm², 0 to 00 B and S
• Material: satin nickel plated forged brass

Warranty

This comes with the manufacturer's warranty through the Australian distributor. See the manufacturer's terms for details, plus our guarantees under the Australian Consumer Law.

FAQ

Quick question: does the BT811-N10 bag contain 10 of the same negative terminal?

All 10 are negative saddle terminals, packed in one bag.

Before I order, how thick a cable can the negative BT811-N10 take?

Projecta lists 50 to 70 mm², 0 to 00 B and S for the main cable.

Fitting it myself, why does the BT811-N10 only suit the negative post?

No. Positive posts are slightly larger than negative ones, so this negative terminal is sized for the negative post only.

What finish is on the BT811-N10 and what hardware comes with it?

It is forged brass polished and plated in satin nickel, and Projecta supplies stainless steel hardware with it.

Doing this in the driveway, replacing a corroded clamp with the negative saddle BT811-N10: anything to watch?

Cut the cable back to clean, bright copper if the old end is green or black, then fit the new terminal and tighten it firmly.