Projecta BT611-P10 Positive Saddle Brass Battery Terminal, Bag of 10

Quick answer

The Projecta BT611-P10 is the Positive Saddle Brass Battery Terminal, Bag of 10. Positive posts are slightly larger than negative posts, so fit this one only to the positive side.

This is the 10 piece bag of positive saddle terminals, handy for workshops restocking the drawer. Positive posts are slightly larger than negative posts, so fit this one only to the positive side.

Clean the post back to bright metal before fitting, and coat the joint once tightened. It takes 20 to 35 mm², 4 to 2 B and S main cable.

The cable sits under a clamping saddle, so bare cable is held without a crimped lug. Material is forged brass, a solid choice for battery connections.

Measure the post and the cable before ordering; a terminal that is too big for the post will never clamp properly. After fitting, a thin smear of terminal grease or spray protector slows corrosion. Check the terminal again after the first week, as new cable can settle under the clamp. Tighten firmly but do not crush the post; a lead post deforms easily. Keep the positive covered so a spanner cannot bridge it to the body. The full <a href="https://frankiesautoelectrics.com.au/collections/projecta">Projecta range</a> has the matching accessories.

Specifications

• Post: positive
• Style: saddle
• Pack: bag of 10
• Main cable: 20 to 35 mm², 4 to 2 B and S
• Material: forged brass

Warranty

This comes with the manufacturer's warranty through the Australian distributor. See the manufacturer's terms for details, plus our guarantees under the Australian Consumer Law.

FAQ

Before I order, how many positive terminals are in a BT611-P10?

All 10 are positive saddle terminals, packed in one bag.

Before I order, will 20 to 35 mm² cable fit the BT611-P10?

Projecta lists 20 to 35 mm², 4 to 2 B and S for the main cable.

Quick question: will a positive saddle terminal fit the opposite post?

No. Positive posts are slightly larger than negative ones, so this positive terminal is sized for the positive post only.

Quick question: my old saddle terminal is cracked; can I just swap in the BT611-P10?

Cut the cable back to clean, bright copper if the old end is green or black, then fit the new terminal and tighten it firmly.

For a customer job, is a terminal protector worth using over a BT611-P10?

Yes. Once it is tight, a thin coat of terminal grease or protector spray over the joint slows corrosion.