Projecta BT59S-10 Crimp End Entry Brass Battery Terminal, Bag of 10

Quick answer

The Projecta BT59S-10 is the Crimp End Entry Brass Battery Terminal, Bag of 10. End entry means the cable runs straight off the post after crimping, handy where space is tight.

Bag of 10 universal crimp end entry terminals, so this one is aimed at workshops restocking the drawer rather than a single car. It takes 25 mm², 3 B and S main cable.

End entry means the cable runs straight off the post after crimping, handy where space is tight. Material is forged brass, a solid choice for battery connections.

Listed as universal, so it is not tied to the positive or negative side. Give the post a clean first; a dirty post will undo a good terminal.

After fitting, a thin smear of terminal grease or spray protector slows corrosion. Keep the positive covered so a spanner cannot bridge it to the body. Tighten firmly but do not crush the post; a lead post deforms easily. If the old terminal was badly corroded, cut the cable back to clean copper before fitting the new one. Measure the post and the cable before ordering; a terminal that is too big for the post will never clamp properly. The full <a href="https://frankiesautoelectrics.com.au/collections/projecta">Projecta range</a> has the matching accessories.

Specifications

• Post: universal
• Style: crimp end entry
• Pack: bag of 10
• Main cable: 25 mm², 3 B and S
• Material: forged brass

Warranty

This comes with the manufacturer's warranty through the Australian distributor. See the manufacturer's terms for details, plus our guarantees under the Australian Consumer Law.

FAQ

Are all 10 terminals in the BT59S-10 universal?

All 10 are universal crimp end entry terminals, packed in one bag.

Which cable sizes fit the crimp end entry BT59S-10?

Projecta lists 25 mm², 3 B and S for the main cable.

When swapping to a BT59S-10, should I cut the cable back first?

Cut the cable back to clean, bright copper if the old end is green or black, then fit the new terminal and tighten it firmly.

Is a terminal protector worth using over a BT59S-10?

Yes. Once it is tight, a thin coat of terminal grease or protector spray over the joint slows corrosion.

Can I overtighten a crimp end entry terminal like the BT59S-10?

Tighten until it cannot be twisted on the post by hand. Going further risks damaging the post or the terminal.