DNA WHD102 Sound Dampening Deadener & Acoustic Enhancing Sheets – 1 Pack Of 6

Description

Self-Adhesive Sound Deadening Sheets With Aluminum Foil Heat Shield.

Sound Deadener Sheets
Increasing your cars acoustic environment is one of the best ways to improve your sound system.

Installation Guide:

1. Remove Interior Upholstery, Trims Or Carpet.
2. Remove Loose Debris, Dirt & Grease To Ensure Sound Deadener Is Stuck To A Clean Surface.
3. Cut DNA Designer Audio Sound Deadener To Desired Size. Be Sure To Allow For Door Trim Plugs & Clips To Be Re-Fitted. Do Not Cover Mechanical Devices, Wires & Drain Plugs.
4. If the Weather Is Less than 18°c Heat Will Need To Be Applied. For Optimum Results Apply Heat To Ensure Maximum Adhesion.
5. Peel Off the Backing Sheet. Bend The Mat Slightly & Attach The Short Edge.
6. Slowly & Firmly Roll Into Position Using A Roller. Be Sure To Remove & Air Pockets Obtaining Strong Bond To The Metal Work.

Recommended Installation Location:

• Doors:
• Inner & Outer Skin To Reduce Road Noise & Improve Musical Mid Bass & Mid Range Vocals Produced By Door Speakers.
• Boot:
• Lid Floor, Quarter Panels, Rear Deck, Wheel Wells To Reduce Road Noise, Exhaust Drone As Well As Increasing Subwoofer SPL & Clarity.
• Floor:
• Cover The Entire Floor Including Under Seats To Reduce Road Noise, Engine Noise, Exhaust & Resist Heat. This Will Enhance Your Current Audio System Sound Quality.
• Roof:
• To Reduce Wind Noise, Radiant Heat & Eliminating Vibrations From The Audio System & Increasing Subwoofer SPL & Clarity.
• Firewall:
• To Reduce Engine Noise, Road Noise & Dissipate Heat.

Specifications:

• Size: 300mm x 300mm Per Sheet.
• Pack Size: 6 Sheets Per Pack
• Total Area Coverage: 600 x 900mm
• Thickness: 2mm
• Packaging: Heat Sealed Blister & Card With 3 Hang Holes.
• Weight: 1.57kg Per Pack.

DNA WHD102 Specs